product description
Construction floodlight films - and concrete pools 100W 12V
For subsequent mounting with no recess
Outer Diameter approx 280mm depth about 72mm
Halogen bulb 100W 12V
ca. 3,0m special cable with sealing to the lamp
Made in EU
Delivery without transformer and cable junction box - can be ordered separately in the shop.
Description:
To illuminate a swimming pool light, the installation of a 100 W spotlight all 25 to 35 m² of water surface. In particularly deep pools a 100 W spotlight for each 30 or 40 m³ of water volume is required. To avoid glare, the spotlight must be installed so that they face away from the residence or usual view of the swimming pool.
When using a lighting or competition pools to train the spotlight must be installed on the sides to prevent glare on the swimmers.
To avoid that for a change the lamp, the water has to be let out of the pool, it is advisable to install the radiator in an easily accessible from the upper edge of the swimming pool space.
General notes and information:
This lamp is designed so that it is suitable for a complete immersion in fresh water of swimming pools. It is an electrical appliance of protection class III with very low safety voltage (12 V AC)
The reflector satisfies the degree of protection IPX8 (resistance to penetration of dust, solid bodies and humidity) at a nominal immersion depth of 2 m.
This radiator complies with international safety standards for lights, especially the EN 60598-2-18: LIGHTS PART 2: SPECIFIC REQUIREMENTS SECTION 18 LIGHTING BODIES FOR POOLS AND SIMILAR APPLICATIONS.
For proper installation it 30 is necessary that the current consumption of the headlight at least with a protective device against residual current with a maximum thickness of. MA
Attention, these small spotlights Bulb Swap NOT can be done under water - The Assembly should therefore be in the upper range but below the water surface
Only suitable for underwater operation!
